What is a temporary power pole?
It is a freestanding pole, often called a spider box's bigger cousin, that holds a meter socket, a breaker panel and outlets so a job site can run saws, lights and pumps before the building has permanent electrical service, and a construction temporary power pole diagram from your electrician will typically show the meter, panel, grounding rod and service drop before anyone breaks ground. Most jobs in Sandy spec a 200 amp temporary power pole because it covers trailers, tools and a few light tower rental units without tripping breakers all day, and that amperage is the baseline most temporary power pole requirements assume for a mid-size site. The pole itself sits on a treated wood post, sunk and braced, with conduit running underground or overhead to the meter, which is the basic layout installing a temporary power pole follows on most Sandy job sites. Every job differs, so a lot of contractors bundle this with temporary fence rental and a portable restroom rental order to get the whole perimeter squared away in one delivery. GFCI protection on the circuits matters here: OSHA 1926.404(b)(1)(ii) requires it on construction sites, and a licensed electrician should be the one pulling the permanent tie-in.
How much does temporary power pole installation cost?
Installation cost depends on amperage, trench length and how far the pole sits from the transformer, and most Sandy contractors budget it as a line item separate from equipment rental. We do not carry a fixed installation price in our data, since the electrician's scope varies site to site, but delivery and setup coordination for the pole itself pairs cleanly with a general delivery fee. For reference, a straightforward delivery fee for site equipment in Sandy runs in this range:
| service | duration | low | typical | high |
|---|---|---|---|---|
| delivery_fee | day | 100 | 150 | 500 |
| delivery_fee | week | 50 | 100 | 150 |
| delivery_fee | month | 120 | 172 | 420 |
Get exact installation numbers from your electrician and treat this table as the equipment-side cost only. If your project also needs a storage container rental or a mobile office trailer rental, ask about bundling drop-offs to shave a trip charge.
Where should a temporary power pole go on a construction site?
Placement should give the electrician clear access for the service drop while keeping the pole out of truck paths and material staging. A roll-off delivery alone needs about 60 feet of straight clearance behind the truck, so if you are also ordering a roll-off dumpster rental or construction dumpster rental, plan the pole and the dumpster pad on opposite ends of the lot. Keep it clear of temporary fence rental lines and away from foot traffic near your standard porta potty rental or ADA accessible porta potty units. OSHA 1926.56(a) sets minimum illumination for work areas, which matters if the pole also feeds a light tower rental at night. A good site diagram marks the pole, the transformer tie point, the dumpster, the fence line and the restrooms before anything gets delivered, since moving a set pole later costs real time. Sandy sites on sloped lots should also confirm drainage away from the base.
Confirming where the utility company wants the drop, and whether Sandy requires a separate inspection, is worth a call before pole day. We do not have Sandy's specific electrical permit fee on file, so check with the city rather than guess. For the sanitation side of the same job, the Porta Potty Rental in Sandy, UT page covers what to order alongside it, and our Porta Potty Rental in Sandy, UT hub links every service we run across town, including Porta Potty Rental in Murray, UT 7.6 miles north and Porta Potty Rental in South Jordan, UT 8.3 miles west for crews working both sides of the valley.
How many amps does a temporary power pole need for construction?
Most general contractors spec 200 amp service for a mid-size job site, enough for saws, compressors, a few light tower rental units and trailer power. Smaller renovation jobs sometimes get by on 100 amp. Your electrician sizes it against your actual tool and trailer load, not a guess.
Do I need a permit for a temporary power pole in Sandy?
Likely yes, since most jurisdictions require an electrical permit and inspection for temporary service. We do not have Sandy's specific permit process verified, so confirm directly with the city before scheduling the utility company's connection.
How long does temporary power pole installation take?
A straightforward install often finishes in a day once the electrician has the pole set and the utility company schedules the meter connection. Trenching, distance to the transformer and inspection scheduling can stretch that timeline.
Can I rent a temporary power pole or do I need to buy one?
Rental is common for short jobs; ask your electrical contractor or rental supplier locally, since Sandy Porta Pros focuses on sanitation, fencing, storage and dumpsters rather than electrical equipment itself.
What else does a construction site need besides power?
Most sites pair power with fencing, a dumpster and restrooms. Check Temporary Fence Rental in Sandy, UT, Roll-Off Dumpster Rental in Sandy, UT and How Many Porta Potties Do I Need in Sandy, UT to plan the rest of the lot.
Next step
Get a delivery date
Tell us the address, the dates and the headcount. We size the order and confirm the route.